Kenwood KDC-BT620U Instruction Manual page 33

INSTALLATION/CONNECTION
Installing the unit (in-dash mounting)
Orientate the trim plate as
illustrated before fitting.
How to remove the unit
1 Detach the faceplate.
2 Fit the catch pin on the extraction keys into the
holes on both sides of the trim plate, then pull it
out.
3 Insert the extraction keys deeply into the slots
on each side, then follow the arrows as shown on
the illustration.
Do the required wiring.
( 34, 35)
Hook on the top side
Bend the appropriate tabs to hold the
mounting sleeve firmly in place.
When installing without the mounting sleeve
1 Remove the mounting sleeve and trim plate from the unit.
2 Align the holes in the unit (on both sides) with the vehicle
mounting bracket and secure the unit with screws (supplied/
commercially available).
The following screws are supplied for:
Dashboard of
your car
Round head screws (M5 × 8 mm)
Flat head screws (M5 × 8 mm)
Sems screws (M4 × 8 mm)
Round head screws (Ø5 × 8 mm)
Flat head screws (Ø5 × 8 mm)
Sems screws (M4 × 8 mm)
Use only the specified screws. Using wrong screws might damage
the unit.
– – – – – or – – – – –
:
× 4 To secure the
mounting
bracket
× 4
To secure the
× 1 ground wire
(black)
:
× 4 To secure the
mounting
bracket
× 4
To secure the
× 1 ground wire
(black)
ENGLISH
33