Kenwood KDC-BT620U Instruction Manual page 23

AUDIO SETTINGS
DTA SETTINGS
For settings, 24, Digital Time Alignment Settings.
CAR SETTINGS
• : For 2-way crossover: [SUB-W LEVEL]/[SUBWOOFER SET] is selectable
only if [SWITCH PREOUT] is set to [SUB-W]. ( 5)
• [SUB-W LEVEL] is selectable only if [SUBWOOFER SET] is set to [ON].
Crossover settings
Below are the available setting items for 2-way crossover and 3-way
crossover.
SPEAKER SIZE
Selects according to the connected speaker size for optimum performance.
• The frequency and slope settings are automatically set for the crossover
of the selected speaker.
• When 2-way crossover is selected, if [NONE] is selected for [TWEETER] of
[FRONT], [REAR] and [SUBWOOFER] for [SPEAKER SIZE], the [X ' OVER] setting of
the speaker is not available.
• When 3-way crossover is selected, if [NONE] is selected for [WOOFER] of
[SPEAKER SIZE], the [X'OVER] setting of [WOOFER] is not available.
X ' OVER
• [FRQ]/[F - HPF FRQ]/[R - HPF FRQ]/[SW LPF FRQ]/[HPF FRQ]/[LPF FRQ]: Adjusts the
crossover frequency for the selected speakers (high pass filter or low
pass filter).
If [THROUGH] is selected, all signals are sent to the selected speakers.
• [F - HPF SLOPE]/[R - HPF SLOPE]/[SW LPF SLOPE]/[HPF SLOPE]/[LPF SLOPE]/[SLOPE]:
Adjusts the crossover slope.
Selectable only if a setting other than [THROUGH] is selected for the
crossover frequency.
• [SW LPF PHASE]/[PHASE]: Selects the phase of the speaker output to be in
line with the other speaker output.
• [GAIN LEFT]/[GAIN RIGHT]/[F - HPF GAIN]/[R - HPF GAIN]/[SW LPF GAIN]/[GAIN]:
Adjusts the output volume of the selected speaker.
2-way crossover setting items
SPEAKER SIZE
FRONT SIZE 8CM/10CM/12CM/13CM/16CM/17CM/18CM/4×6/
5×7/6×8/6×9/7×10
TWEETER SMALL/MIDDLE/LARGE/NONE (not connected)
REAR 8CM/10CM/12CM/13CM/16CM/17CM/18CM/4×6/5×7/6×8/6×9/
7×10/NONE (not connected)
SUBWOOFER * 1
16CM/20CM/25CM/30CM/38CM OVER/NONE (not connected)
X ' OVER
TWEETER FRQ 1KHZ/1.6KHZ/2.5KHZ/4KHZ/5KHZ/6.3KHZ/8KHZ/
10KHZ/12.5KHZ
GAIN LEFT –8 to 0
GAIN RIGHT –8 to 0
FRONT HPF F - HPF FRQ 30HZ/40HZ/50HZ/60HZ/70HZ/80HZ/90HZ/100HZ/
120HZ/150HZ/180HZ/220HZ/250HZ/THROUGH
F - HPF SLOPE –6DB/–12DB/–18DB/–24DB
F - HPF GAIN –8 to 0
REAR HPF R - HPF FRQ
R - HPF SLOPE (Refer FRONT HPF settings above.)
R - HPF GAIN
SUBWOOFER SW LPF FRQ 30HZ/40HZ/50HZ/60HZ/70HZ/80HZ/90HZ/100HZ/
LPF * 1
120HZ/150HZ/180HZ/220HZ/250HZ/THROUGH
SW LPF SLOPE –6DB/–12DB/–18DB/–24DB
SW LPF PHASE REVERSE (180°)/NORMAL (0°)
SW LPF GAIN –8 to 0
* 1
Selectable only when [SWITCH PREOUT] is set to [SUB-W] ( 5) (for
and [SUBWOOFER SET] is set to [ON]. ( 22)
),
23
ENGLISH