Lan Cable - Fujitsu DX100 S3 Setup Manual

LAN Cable

1
● MNT port
A port that is used to connect to an operation management LAN. Before connecting to the operation
management LAN, change the IP address of the MNT port in the Setup Network Environment settings.
● RMT port
A port that is used for initial setup or to connect to the remote support center.
Cable
Host Interface Cable
2
Connect a Host Interface cable to each of these ports.
Cable
● FC,
iSCSI 10Gbit/s (10GBASE-SR),
FCoE,
Ethernet 10Gbit/s
(for FC cable connection)
● iSCSI 10Gbit/s (10GBASE-SR),
FCoE,
Ethernet 10Gbit/s
(for Copper Twinax cable
connection)
● iSCSI 10Gbit/s (10GBASE-T),
iSCSI 1Gbit/s,
Ethernet 1Gbit/s
SAS
●
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Hybrid Storage Systems Setup Guide
Rear view
Controller (CM#0)
RMT port MNT port
Rear view
CA#1 CA#0
CA#0 CA#1
FC iSCSI 10Gbit/s (10GBASE-SR)
, ,
FCoE Ethernet 10Gbit/s
,
for FC cable connection
( )
Port#0 Port#1
iSCSI 10Gbit/s (10GBASE-T),
iSCSI 1Gbit/s
Port#0 Port#1
Ethernet 1Gbit/s
Port#0 Port#1 Port#2 Port#3
6
Copyright 2017 FUJITSU LIMITED
Controller (CM#1)
RMT port MNT port
CA#1 CA#0
CA#0 CA#1
iSCSI 10Gbit/s (10GBASE-SR),
FCoE Ethernet 10Gbit/s
,
(for Copper Twinax cable connection)
Port#0 Port#1
SAS
Port#0 Port#1
Controller enclosure
Controller enclosure
Controller enclosure
P3AM-7852-06ENZ0