Usb Board - HP Pavilion 14 Maintenance And Service Manual

USB board

Description
USB board for use in models with 4 GB of discrete graphics memory
USB board for use in models with UMA graphics memory or 2 GB of discrete graphics memory
USB board cable
Before removing the USB board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
To remove the USB board:
1. Disconnect the cable (1) from the USB board.
2. Remove the Phillips PM2.0×2.5 screw (2) and the two Phillips PM2.0×5.0 screws (3) that secure the USB
board to the computer.
3. Rotate the connector side of the board up, and then lift the board out of the computer.(4).
Reverse this procedure to install the USB board.
Bottom cover on page
Battery on page 31).
29).
Component replacement procedures
Spare part number
927924-001
927925-001
927914-001
43