Hardware Installation - D-Link DCS-1110 Quick Install Manual

Hardware Installation

Hardware Installation
Attach the External Power Supply
Attach the external power supply to the
DC power input connector located on the
Internet Camera's back panel (labeled
DC 5V) and connect it to an AC power
outlet.
Note: The power supply is optional if the
PoE (Power over Ethernet) is used.
Power source is confirmed when the LED Power Indicator on the
Internet Camera is illuminated.
Connect the Ethernet Cable
Connect an Ethernet cable to the Ethernet
connector located on the Internet Camera's
back panel and attach it to the network.
If you connect this camera directly to a PC,
the DCS-1110 has an MDI/X port that will
allow you to use either a straight through
(included) or cross-over cable.
The LAN LED will light orange when there is a good connection to the
LAN. The LED will begin to flash indicating the camera is receiving or
sending data.
5 D-Link DCS-1110 Quick Install Guide