Calibrating The Tilt; How To Perform 360º Stunt Rolls - Propel RC TILT Instruction Booklet

CALIBRATING THE TILT™

NOTE:Your TILT ™ comes pre-calibrated out of the box so you are ready to fly.
After several crashes and shock to your gyro sensors,you may notice that your drone is drifting and not
holding its center position as well as it used to.
This most likely means that you need to recalibrate the 6 axis gyro.Please follow the simple instructions
below.
1. Place the TILT ™ on a level surface
2.Make sure the TILT ™ is on and that the controller is synced (refer to syncing pg 4.).Do not start the
blades.Instead move both the throttle and control stick down and to the right corner and hold them
there for 5 seconds(See Diagram R).You will see the lights on the drone rapidly flash and stop.Once the
lights stop flashing you have completed your calibration and are ready to fly!
TROUBLE SHOOTING: If you do not see the lights flash,first remove the battery from the drone then turn off
your controller and start again.Always make sure to put your battery in first,then turn on your controller.
Push the left throttle stick up all the way and then pull back down again.When you hear the beep the TILT™
is synced to the controller and you are ready to calibrate.
R
9
HOW TO PERFORM 360º STUNT ROLLS
Performing 360º stunt rolls with the TILT ™ is as easy as 1-2-3:
1. Hover the TILT ™ in still position making sure that you have at least 5 feet of clearance above
and below the quadrocopter,Set the speed settings to mode 2 or 3.
2. Press the 360 stunt button down and you will enter the stunt roll mode which is indicated by a rapid
beeping (see diagram S).
3. Determine which direction you want it to flip and quickly push the right control stick in the direction
you want to flip your TILT ™ (see diagram T).
You have 4 choices a) Forward roll, b) Backwards roll, c) Right side roll, d) Left side roll.
360˚Stunt Roll Button
S T
10