Front Panel Components - D-Link DGS-1510-10L/ME Hardware Installation Manual

DGS-1510/ME Series Metro Ethernet Switch Hardware Installation Guide

Front Panel Components

The front panel of the Switch features a variety of ports and LED indicators that will be discussed in detail in this
section. Also located on the front panel of the Switch is a pinhole that can be pressed and held for 5 seconds to
perform a hardware factory reset on the Switch after which the Switch will reboot. This will clear all the software
modifications done on the Switch to their factory default settings. Zero Touch Provisioning (ZTP) will be supported in
the next ME Series release.
Figure 1-1 Front panel view of a DGS-1510-10L/ME Switch
Figure 1-2 Front panel view of a DGS-1510-20L/ME Switch
Figure 1-3 Front panel view of a DGS-1510-28L/ME Switch
Figure 1-4 Front panel view of a DGS-1510-28LP/ME Switch
Figure 1-5 Front panel view of a DGS-1510-28X/ME Switch
Figure 1-6 Front panel view of a DGS-1510-28XMP/ME Switch
Figure 1-7 Front panel view of a DGS-1510-28XS/ME Switch
8