Creating A User Account - D-Link DGS-1510-10L/ME Hardware Installation Manual

DGS-1510/ME Series Metro Ethernet Switch Hardware Installation Guide
After the Switch was successfully booted up, the username prompt will appear, as shown below.
UserName:
By default, there is no login user account configured on this Switch. Simply press the Enter key twice and the CLI
input cursor (DGS-1510-28XMP/ME:admin# ) will be available, as shown below.
UserName:
PassWord:
DGS-1510-28XMP/ME:admin#
Now the switch can be configured.
NOTE: By default, there are no login user accounts configured on this Switch. For security
reasons, it is highly recommended to create a login user account for this Switch.

Creating a User Account

This section will discuss how to create a login user account on this Switch. This login details will be applied not only
for access to the CLI, but also for access to the Web UI and other interfaces. The same username and password will
be used for these connections.
To create a user account, enter the following commands.
DGS-1510-28XMP/ME:admin# create account admin Administrator
Command: create account admin Administrator
Enter a case-sensitive new password:********
Enter the new password again for confirmation:********
Success.
DGS-1510-28XMP/ME:admin#
In the above example, the create account command was used to create a new user account. An admin account was
created with the username of 'Administrator'. Immediately after the command was issued, the new password must be
entered and verified. Press Enter after every step to continue.
For more information about user account creation and management, refer to the DGS-1510/ME Series CLI Reference
Guide and the DGS-1510/ME Series Web UI Reference Guide.
DGS-1510-28XMP/ME Gigabit Ethernet Switch
Command Line Interface
Firmware: Build 1.00.018
Copyright(C) 2015 D-Link Corporation. All rights reserved.
DGS-1510-28XMP/ME Gigabit Ethernet Switch
Command Line Interface
Firmware: Build 1.00.018
Copyright(C) 2015 D-Link Corporation. All rights reserved.
30