Disconnect Button; Reset Button - D-Link DNS-120 Manual

Usb to ethernet network storage adapter

Hide thumbs Also See for DNS-120:

Table of Contents

Disconnect Button

The Disconnect button is located on the back panel of the DNS-120. This button will

safely disconnect all attached USB drives on the DNS-120.

To safely remove a USB drive from the DNS-120, press the Disconnect button on the

back panel until the USB LED blinks red. After the USB LED turns off, it is safe to

remove all USB drives from the DNS-120.

Note: If a USB drive remains attached to the DNS-120 after being disconnected, it will

no longer be accessible. That USB drive must be reconnected in order to be available

for access again.

To ensure that risk of data loss is minimized, it is important to make sure that no

users are currently accessing files on the DNS-120 while disconnecting USB drives is

in progress.

To reset the DNS-120 to factory default settings, press the reset button for 5 seconds

and release. The Ethernet LED will turn off momentarily, and then light green.

Wait approximately 30 seconds for the DNS-120 to complete the reset cycle before you

begin using it again.

Table of Contents