10 Easy Steps to Quick Installation
For the CG 2400 PC Cordless Phone System
N
:
O TE
Do not attach the base
station to your PC until instructed
to do so. If you run into difficulties, see
"Chapter 2: Installation" in your CG
2400 User Guide for more information.
1
Unpack the Components
DA 202 Base station
2 standard
phone cords
Base
station
desk
USB
stand
cable
Handset
charger
Base station
power supply
DG 200 Handset
with detachable clip
Handset power supply
Not shown:
Base station wall mount
•
Battery pack for the handset
•
CyberGenie@Work CD-ROM
•
CG 2400 User Guide
•
Handset Quick Reference
•
2
Install the Handset Battery
a
Remove the cover from the back of the
handset.
b
Plug the battery wire into the white
connector inside the handset at the top
right.
c
Route the wire through the guide.
d
Place the battery securely inside the
battery compartment.
e
Replace the cover.
3
Charge the Handset
N
:
OTE
If using the wall mount, install
mount on wall before connecting the
charger to the mount.
a
Insert the power supply plug into the
socket on the back of the charger.
b
Attach the mount to the charger.
c
Plug the power supply into an approved
electrical outlet.
d
If the handset is on, press
until the
handset turns off.
e
Insert the handset securely into the
charger.
f
While charging, the green indicator light
on the charger will be on. When the
handset is fully charged, the indicator
light will go off.
N
:
OT E
Let your handset charge for at
least three hours before first use.
4
Before Installing Software
a
Close any open software programs.
b
From the Windows Start menu, select
Settings> Control Panel.
c
Click Power Management .
d
On the Power Schemes tab, select
Always On.
e
Select Never for System standby (not
present in all installations).
f
Select Never for Turn off hard disk.
g
Click OK to save.
N
:
OT E
If using Microsoft
®
Outlook
®
,
see " Ensuring Outlook Support" on
page20 of your CG 2400 User Guide
before installing CyberGenie@Work.
5
Install the Software
N
:
OT E
Do not attach the base
station to your PC until instructed
to during the installation process!
a
Insert the CyberGenie@Work CD into
your CD-ROM drive.
b
When the installation program loads,
click Install.
c
Follow the screen instructions until the
prompt appears: Connect the base
station to your PC USB port. At this
point, pause the software installation
procedure and prepare the base station.
6
Prepare the Base Station
a
Remove the warning
sticker on the bottom
of the base station so
the sockets are
visible.
b
Mount base station:
For desktop use ,
attach the base
station to the stand as
shown.
For wall mounting,
see "To mount the
base station:" on
page23 of your CG
2400 User Guide.
Line 1 socket
Fax/modem socket
USB connection
Line 2
Power
socket
socket
Wire Guides