Before You Begin - Razor RAZORX CRUISER Owner's Manual

BEFORE YOU BEGIN

Remove contents from box. Remove the separators that protect the components from damage during shipping. Inspect
the contents of the box for scratches, or dents that may have occurred during shipping. Because the RazorX Cruiser
Electric Skateboard was 99% assembled and packed at the factory, there should not be any problems, even if the box
has a few scars or dents.
MAKE SURE POWER SWITCH IS TURNED "OFF" BEFORE CONDUCTING ANY ASSEMBLY OR
MAINTENANCE PROCEDURES.
Estimated Assembly and Set-Up Time
Allow up to 5 minutes for assembly, not including initial charge time.
Allow up to 8 hours for charge (see page 6 for charging information).
Charger
(Note: Charger design may
vary from one shown)
LED Indicator
Power Button
Pairing Button
Motor
Charger Port
Battery
Need Help? Visit our web site for replacement parts, product support, a list of authorized service centers in the US and customer service contact information
at www.razor.com. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer Service
contact information is listed at the back of this manual.
2.
1.
Wheel
3
DO NOT USE NON-RAZOR
PRODUCTS WITH YOUR
RAZORX CRUISER
ELECTRIC SKATEBOARD.
The RazorX Cruiser Electric
Skateboard has been built
to certain Razor design
specifications. The original
equipment supplied at the time
of sale was selected on the
basis of its compatibility with
the frame and all other parts.
Certain aftermarket products
may not be compatible and will
void the warranty.
Note: RazorX Cruiser Electric
Skateboard must be moving
at least 3 mph (5 km/h) while
holding the lever on the remote
Remote
in the "GO" position for motor to
engage.
Product ID Locations:
(See locations to the left)
1. Underneath Product
2. Charger
3. UPC Side of Box (Not Shown)
Box Contents:
• RazorX Cruiser Electric
• Remote
• Two (2) AAA Batteries
• Charger
• Owner's Manual
WARNING:
Skateboard