Olivetti d-Color MF2613En Service Manual page 153

Code Contents
3100 ISU home position error
The home position is not cor-
rect when the power is turned
on or at the start of copying
using the table.
3200 Exposure lamp error
The exposure lamp does not
turn on when power is on.
The lamp's luminosity does
not stabilize in one minute
after power is on.
Error is detected while pro-
cessing lamp feedback in
standby.
Y116650-5
Causes
Defective connec- Reinsert the connector. Also check for conti-
tor cable or poor nuity within the connector cable. If none,
contact in the con- replace the cable.
nector. Home position sensor and CCD PWB (YC3)
CCD PWB (YC1) and main PWB (YC8)
ISU motor and main PWB (YC36)
Defective home Replace the home position sensor.
position sensor.
Defective ISU Replace the ISU motor.
motor.
Defective CCD Replace the scanner unit (see page 1-5-48).
PWB.
Defective main Replace the main PWB and check for cor-
PWB. rect operation (see page 1-5-30).
Defective connec- Reinsert the connector. Also check for conti-
tor cable or poor nuity within the connector cable. If none,
contact in the con- replace the cable.
nector. Exposure lamp and inverter PWB (CN2)
Inverter PWB (CN1) and CCD PWB (YC3)
CCD PWB (YC1) and main PWB (YC8)
Defective exposure Replace the scanner unit (see page 1-5-48).
lamp.
Defective inverter Replace the scanner unit (see page 1-5-48).
PWB or CCD
PWB.
Defective main Replace the main PWB and check for cor-
PWB. rect operation (see page 1-5-30).
1-4-17
Check procedures/
corrective measures
Service Manual
2PV/2PW