Attaching The Accessory Connector Cover; Attaching The Belt Clip - Motorola APX7000 User Manual

Attaching the Accessory Connector
Cover
The accessory connector is located on the antenna side of the
radio. It is used to connect accessories to the radio.
Note: To prevent damage to the connector, shield it with the
connector cover when not in use.
Insert the hooked
Hooked End
end of the cover
into the slot above
the connector.
Press downward on
the cover's top to
Hex Socket
Head
seat it in the slot.
Once in place, rotate
the thumbscrew
clockwise by hand
until tight.
Thumbscrew
To remove the accessory connector cover, rotate the
thumbscrew counterclockwise until it disengages from the radio.
If the thumbscrew is too tight, use an Allen wrench to loosen
it first.
Rotate and lift the connector cover to disengage it from
the radio.

Attaching the Belt Clip

Align the grooves of the
belt clip with those of the
radio and press upward
until you hear a click.
To remove the clip, use a
flat-bladed object to press
the belt clip tab away from
the radio. Then, slide the
clip downward and away
from the radio.
English
5