Setup - Graco Magnum Pro Plus Series Operation, Parts

Setup

When unpacking sprayer for the first time or
after long term storage perform setup
procedure.
Assemble Your Sprayer
1. Connect Graco airless hose to fluid
outlet. Use wrench to tighten securely.
ti27122a
2. Connect other end of hose to gun.
3. Use two wrenches to tighten securely. If
hose is already connected, make sure
connections are tight.
4. Engage trigger lock.
5. Remove tip guard. Be careful tip seal
may fall out when tip guard is removed.
3A3240C
ti25197a
6. Turn pressure control knob all the way
left (counter-clockwise) to lowest set-
ting.
7. After long term storage check inlet
strainer for clogs and debris.
Strain the Paint
ti25199a
Previously opened paint may contain dried
paint or other debris. To avoid priming prob-
lems and spray tip clogs it is recommended
to strain the paint before using. Paint strain-
ers are available where paint is sold. Stretch
a paint strainer over a clean pail and pour
the paint through the strainer to capture any
dried paint and debris before spraying.
ti25196b
Setup
ti27493a
ti26894a
9