Running A Product Check - Epson L380 User Manual

Light status
The paper light is on
The power light is on
The ink light is on
The ink light is flashing
The paper light is flashing
The ink light is on
The paper light is on
The power light is flashing
The ink light is flashing
The paper light is flashing
Parent topic:
Related references
Paper Jam Problems
Where to Get Help
Related topics
Loading Paper
Refilling Ink

Running a Product Check

Running a product check helps you determine if your product is operating properly.
1. Press the
2. Disconnect any interface cables connected to your product.
3. Load plain paper in the product.
4. Hold down the
5. When the product turns on, release both buttons.
Condition/solution
No paper is loaded or multiple sheets fed at one time. Load paper in the
product, and press the
button to clear the error.
Initial ink charging may not be complete. See the Start Here poster for
instructions.
The ink pads need to be replaced. You must contact Epson for support.
An error has occurred during firmware updating. Connect your product
using a USB cable and try updating the firmware again. If the error
continues, contact Epson for support.
Open the scanner unit and remove any paper or protective materials
inside the printer. Turn the product off and then back on again.
Solving Problems
power button to turn off the product.
stop button and press the
B&W copy button or the
power button to turn on the product.
107
color copy