Kenmore 146.34611411 Use & Care Manual page 26

Side burner
□ Loosen side burner in side shelf. (B ). To loosen, unscrew and remove two front screws and washers
□ Remove the 2 pre-installed screws from the valve stem and set them aside. (C)
□ Insert valve stem through hole in fascia. (D). Install previously removed 2 screws .Note: Leave a
□ Attach bezel to fascia and valve face with the installed screws. Make sure the black mark is facing
□ Place sideburner tube over the valve, making sure that valve is inside sideburner tube. (H)
□ Push control knob onto sideburner valve stem. (I)
□ Reattach sideburner to sideburner shelf with the 2 previously removed screws. Replace sideburner
□ Connect both igniter wires to the igniter module on the inside of the right fascia. To connect, push
□ Unscrew igniter cap from control panel. Insert (1) AA battery (provided in blister pack) into battery
A
D
G
J
26 • 146.34611411
holding sideburner in place. (A). Note: Do not loosen electrode screw.
1/8-inch gap below the screw heads for bezel attachment. (E).
up.(F). Tighten the 2 screws.(G)
grate. (J)
igniter wire tips onto pins in igniter module.(K)
slot with positive end (+) facing outward. Screw igniter cap back onto panel. (L)
B
E
H
K
C
F
I
L