Setting Up - BT On-Air 1800 User Manual

Setting up

Your handset is already registered to the base.
Situate your base close enough to the
telephone and mains power sockets so that the
cables will reach.
The only way to disconnect the product from
the power supply is to remove the power
adaptor from the mains power socket.
Therefore you must ensure you plan the
location so that the mains power is easily
accessed.
Make sure it is at least 1 metre away from
other electrical products to avoid interference.
Do not situate the product in the bathroom or
other humid areas.
Important
You must thread the power supply cable
and line cord through the plinth before you
connect into the sockets on the base.
Plug the power supply cable into the socket on
the underside of your base. The power cable
connector and socket are coloured red.
Plug the line cord into the other socket on the
underside of the base marked with a telephone
symbol.
Please take care that the power supply and
telephone line cord are connected to the
correct sockets as incorrect placement could
damage your equipment.
Once connected, put the plinth back on the base
to prevent it from rocking on the table.
There are two positions for the plinth when
joining it to the base, both can be used for desk
mounting and one for wall mounting. Position
A is for desk mounting only and position B is
for desk or wall mounting (see wall mounting
on page 51).
A
plinth
B
9