Table of Contents
Advertisement
RUGGEDCOM RSG2300
Installation Guide
Figure 30: Installing a GBIC Optical Port
1. GBIC Optical Port Module
5.
Release the latches and make sure the module is locked in place.
6.
Remove the dust cover from the port.
7.
Connect a cable to the port and test the connection.
Section 3.4.2
Removing a GBIC Optical Port
To remove an GBIC optical port, do the following:
CAUTION!
Electrical hazard – risk of damage to equipment. Make sure all electrostatic energy is dissipated before
performing installing or removing components from the device. An electrostatic discharge (ESD) can
cause serious damage to the component once it is outside the chassis.
1.
Make sure all potential electrostatic build-up has been properly discharged to prevent electrostatic
discharges (ESD). This can be accomplished by wearing an ESD wrist strap or by touching Earth or the
chassis ground.
2.
Disconnect the cable from the port.
3.
Squeeze the latches on either side of the port and pull it from the module.
Removing a GBIC Optical Port
2. GBIC Optical Port
3. Locking Latch
1
2
3
Chapter 3
Communication Ports
25
Advertisement
Table of Contents
