Mounting The Device To A Panel - Siemens RUGGEDCOM RSG2300 Installation Manual

Chapter 2
Installing Device
2
Figure 3: DIN Rail Mounting
1. Panel/DIN Rail Adapter
2. Install one of the supplied screws on either side of the device to secure the adapters to the DIN rails.
Section 2.1.3

Mounting the Device to a Panel

For panel installations, the RUGGEDCOM RSG2300 can be equipped with panel/DIN rail adapters pre-installed
on each side of the chassis. The adapters allow the device to be attached to a panel using screws.
To mount the device to a panel, do the following:
1. Place the device against the panel and align the adapters with the mounting holes.
8
3
2. DIN Rail 3. Screw
RUGGEDCOM RSG2300
Installation Guide
1
3
2
Mounting the Device to a Panel