Fitting The Optional Roof Flue Kit - IDEAL LOGIC COMBI ESP1 24 Installation And Servicing

2.12 FITTING THE OPTIONAL ROOF FLUE KIT (FLAT OR PITCHED)
Note.
A flat or pitched roof flashing plate (not supplied) is required before proceeding
with the installation of this kit.
This kit is suitable for both flat and pitched roof terminations, using a concentric
flue to run vertically from the top of the boiler and terminating above roof level.
Connection to the top of the boiler is made using the supplied vertical
connector.
WEATHER PROOFING
Where the flue passes through the roof line an adequate seal must be made.
This is achieved by using either:
- Flat roof weather collar
or
- Universal weather collar.
ACCESSORIES
Flue Duct Extension Kits are available for flue lengths extending beyond 1m.
These packs contain 1m extension ducts and may be cut to the desired length.
If the offset vertical option is used an Elbow Kit is required.
Please visit www.idealboilers.com to access the Flue and Accessories Guide
for this boiler.
Installation and Servicing
SECTION 2 - INSTALLATION
25