Yamaha 2008 XV250X Owner's Manual page 69

1. Axle nut
2. Axle nut cotter pin
3. Chain puller locknut
4. Drive chain slack adjusting nut
5. Alignment marks
3. Loosen the axle nut and the brake
torque rod nut at the brake shoe
plate.
4. Lift the rear wheel off the ground
according to the procedure on
page 6-31.
5. Remove the brake pedal free play
adjusting nut, and then disconnect
the brake rod at the brake cam-
shaft lever.
6. Disconnect the brake torque rod
from the brake shoe plate by re-
moving the nut and the bolt.
PERIODIC MAINTENANCE AND MINOR REPAIR
1. Brake torque rod
2. Brake torque rod bolt and nut
3. Brake rod
4. Brake pedal free play adjusting nut
5. Brake camshaft lever
7. Push the wheel forward, and then
remove the drive chain from the
rear sprocket.
NOTE:
The drive chain does not need to be
disassembled in order to remove and
install the rear wheel.
8. Remove the axle nut.
9. Pull the wheel axle out, and then
remove the wheel.
6-34
To install the rear wheel
1. Install the drive chain onto the rear
sprocket, and then install the
wheel by inserting the wheel axle
from the right-hand side.
2. Install the brake rod onto the brake
camshaft lever, and then install the
brake pedal free play adjusting nut
onto the brake rod.
3. Connect the brake torque rod to
the brake shoe plate by installing
the bolt and nut, and then tighten
the bolt to the specified torque.
Tightening torque:
Brake torque rod bolt:
23 Nm (2.3 m·kgf, 17 ft·lbf)
4. Adjust the drive chain slack. (See
page 6-20.)
5. Install the axle nut, and then lower
the rear wheel so that it is on the
ground.
6. Tighten the axle nut to the speci-
fied torque, and then insert a new
cotter pin into the axle nut.
EAU32760
6