Yamaha 2008 XV250X Owner's Manual page 43

NOTE:
Skip steps 4–6 if the oil filter element is
not being replaced.
4. Remove the oil filter element cover
by removing the screws.
1. Screw
2. Oil filter element cover
5. Remove and replace the oil filter
element and O-ring.
PERIODIC MAINTENANCE AND MINOR REPAIR
1. Oil filter element
2. O-ring
6. Install the oil filter element cover by
installing the screws, then tighten-
ing them to the specified torque.
Tightening torque:
Oil filter element cover screw:
7 Nm (0.7 m·kgf, 5.1 ft·lbf)
NOTE:
Make sure that the O-ring is properly
seated.
7. Install the engine oil drain bolt, and
then tighten it to the specified
torque.
6-8
Tightening torque:
Engine oil drain bolt:
34 Nm (3.4 m·kgf, 24 ft·lbf)
8. Add the specified amount of the
recommended engine oil, and then
install and tighten the oil filler cap.
Recommended engine oil:
See page 8-1.
Oil quantity:
With oil filter element replacement:
1.60 L (1.69 US qt) (1.41 Imp.qt)
Without oil filter element replace-
ment:
1.40 L (1.48 US qt) (1.23 Imp.qt)
NOTE:
Be sure to wipe off spilled oil on any
parts after the engine and exhaust sys-
tem have cooled down.
CAUTION:
G In order to prevent clutch slip-
page (since the engine oil also
lubricates the clutch), do not
mix any chemical additives. Do
not use oils with a diesel speci-
fication of "CD" or oils of a high-
6
ECA11620