Advertisement
place. To insert a screwdriver bit into the Quick
Connect
hex shaft, push the bit in until you
TM
hear it click into place. To remove the bit, hold
the drill as shown in Figure 7. Push in evenly on
the spring loaded disc with two fingers and pull
the bit straight out.
Note: Hex shanks only
Drilling/screwdriving
- Select forward or reverse rotation using the
forward/reverse slider (2).
- To switch the tool on, press the switch (1).
The tool speed depends on how far you press
the switch.
- To switch the tool off, release the switch.
Hints for optimum use
Drilling
- Always apply a light pressure in a straight line
with the drill bit.
- Just before the drill tip breaks through the other
side of the workpiece, decrease pressure on the
tool.
- Use a block of wood to back up workpieces
that may splinter.
- Use spade bits when drilling large diameter
holes in wood.
- Use HSS drill bits when drilling in metal.
- Use masonry bits when drilling in soft
masonry.
- Use a lubricant when drilling metals other than
cast iron and brass.
- Make an indentation using a centre punch at
the centre of the hole to be drilled in order to
improve accuracy.
Screwdriving
- Always use the correct type and size of
screwdriver bit.
- If screws are difficult to tighten, try applying
a small amount of washing liquid or soap as a
lubricant.
- Always hold the tool and screwdriver bit in a
straight line with the screw.
Maintenance
Your Black & Decker tool has been designed to
operate over a long period of time with a mini -
mum of maintenance.
Continuous satisfactory operation depends upon
proper tool care and regular cleaning.
Your charger does not require any maintenance
apart from regular cleaning.
Warning! Before performing any mainte -
nance on the tool, remove the battery from the
tool. Unplug the charger before cleaning it.
- Regularly clean the ventilation slots in your tool
and charger using a soft brush or dry cloth.
- Regularly clean the motor housing using a
damp cloth. Do not use any abrasive or solvent-
based cleaner.
- Regularly open the chuck and tap it to remove
any dust from the interior.
Protecting the environment
Separate collection. This product must
not be disposed of with normal house -
hold waste.
Should you find one day that your Black &
Decker product needs replacement, or if it is of
no further use to you, do not dispose of it with
household waste. Make this product available for
separate collection.
Separate collection of used products
and packaging allows materials to
be recycled and used again. Re-use
of recycled materials helps prevent
environmental pollution and reduces
the demand for raw materials.
Local regulations may provide for separate col -
lection of electrical products from the household,
at municipal waste sites or by the retailer when
you purchase a new product.
Black & Decker provides a facility for the collec -
tion and recycling of Black & Decker products
once they have reached the end of their working
life. To take advantage of this service please re -
turn your product to any authorised repair agent
who will collect them on our behalf.
You can check the location of your nearest
authorised repair agent by contacting your local
Black & Decker office at the address indicated
in this manual. Alternatively, a list of authorised
Black & Decker repair agents and full details of
our after-sales service and contacts are available
on the Internet at: www.2helpU.com
8
Advertisement
