Craftsman 137.322850 Operator's Manual page 44

SAWDUST
Periodically, sawdust will accumulate
under the work table and base. This
could cause difficulty in the movement
of the worktable when setting up
a miter cut. Frequently blow out or
vacuum up the sawdust.
Remove small pieces of material
from the table cavity if needed. (See
the section on REMOVING AND
INSTALLING THE TABLE INSERT on
page 22.)
To empty the dust bag, remove the
sawdust bag from the dust collection
elbow. Open the zipper on the sawdust
bag and empty out the sawdust inside.
Close the zipper and reinstall the dust
bag as described on page 19.
WARNING
!
Wear proper eye protection to keep
debris from entering eyes when
removing sawdust from unit.
LUBRICATION (FIG. SS)
All the motor bearings in this tool are
lubricated with a sufficient amount of
high grade lubricant for the life of the
unit under normal operating conditions;
therefore, no further lubrication
is required.
Lubricate the following as necessary:
Chop pivot: Apply light machine oil to
points indicated in illustration.
Central pivot of plastic guard: Use
light household oil (sewing machine oil)
on metal-to-metal or metal-to-plastic
guard contact areas as required for
smooth, quiet operation. Avoid excessive
oil, to which sawdust will cling.
Fig. SS
Central pivot of
plastic guard (oil here)
44
Chop Pivot (oil here
and on opposite side)