Craftsman 137.322850 Operator's Manual page 29

● WARNING: Do not attempt to
repair or disassemble the laser.
If unqualified persons attempt
to repair this laser product,
serious injury may result. Any
repair required on this laser
product should be performed by
a qualified service dealer.
Fig. Y
Laser Aperture
Label
LASER TRAC ADJUSTMENT
®
(FIG. Z, AA, BB, CC)
NOTE: All the adjustments for the
operation of this machine have been
completed at the factory. Due to
normal wear and use, some occasional
readjustments may be necessary.
WARNING
!
To prevent serious injury, insert a
padlock (not provided) or chain with
padlock through the hole in the ON/OFF
Trigger Switch prior to making any
laser adjustment. DO NOT remove the
lock from the ON/OFF Trigger Switch
during any laser adjustment.
Laser Warning
Label
A. Checking Laser Line Alignment
(Fig. Z, BB)
1. Set the saw to a 0° miter and 0°
bevel setting.
2. Use a combination square to mark
a 90° angled running across the top
and down the front of a board. This
line will serve as the pattern line
(Fig. BB) to adjust the laser. Place
the board on the saw table.
3. Carefully lower the saw head down
to align the saw blade with the
pattern line. Position the saw
blade to the left, center or right
side of the "pattern line" depending
on your preference for the laser line
location. Lock board in place with
hold-down clamp.
4. With the saw plugged in, turn on
the Laser Trac
preset with the laser line to the left
side of the blade.
WARNING: When making laser line
adjustments, keep fingers away
from the ON/OFF trigger switch
to prevent accidental starting and
possible serious injury.
5. Slide the cutting head forward
enough so that the laser line is
visible on the front of the board.
6. Looking at the front of the board,
if the laser line is not parallel to
the "pattern line" please follow the
instructions listed below under
"Front Line" paragraph.
7. Looking at the top of the board,
if the laser line is not parallel to
the "pattern line" please follow the
instructions listed below under "Top
Line" paragraph.
29
. Your saw has been
®