Installing The Upper Handle - Toro 38640 Operator's Manual

1. Installing the Upper Handle

Note: Do not remove the rubber band until you have
installed the upper handle.
1. Lift and rotate the upper handle and position it over
the lower handle (Figure 3).
Important: Route the cables attached to the
Quick Stick inside the upper handle legs and
ensure that the cables and the wire for the headlight
are not pinched between the handle sections.
1
Figure 3
1. Cables
2. Secure the upper handle with 4 handle bolts, 4 curved
washers, and 4 locknuts from the loose parts bag (Figure
4).
Figure 4
2. Installing the Wheel Clutch
Cable Ends
1. Unwrap the cable ends from the lower handle (Figure 5).
Figure 5
2. Route either the left or right cable end over the lower
handle and insert the cable end into the hole in the
corresponding wheel clutch lever (Figure 6).
G000983
Figure 6
1. Wheel clutch lever
3. Remove the nut and washer from the handle, attach
the cable clamp on the cable to the handle, and hand
tighten the nut (Figure 7).
G000984
Figure 7
1. Cable clamp
Important: Ensure that the curved side of the
cable clamp is against the handle and that the cable
is routed below the clamp bolt. The cable must be
in a straight line from the cable clamp to the point
where it attaches to the wheel clutch lever.
6
1
G001303
G001302
1
G001304