Installing The Upper Handle - Toro 38622 Operator's Manual

1. Installing the Upper Handle

Note: Do not remove the rubber band until you have
installed the upper handle.
1. Lift and rotate the upper handle and position it over
the lower handle (Figure 3).
Important: Route the cables attached to the
Quick Stick inside the upper handle legs and
ensure that the cables and the wire for the headlight
are not pinched between the handle sections.
Figure 3
1. Cables
2. Secure the upper handle with 4 handle bolts, 4 curved
washers, and 4 locknuts from the loose parts bag (Figure
4).
Figure 4
2. Installing the Traction
Control Linkage
1. Remove the hairpin cotter and washer from the lower
end of the speed control rod and insert the lower end
of the rod into the lower link arm so that the bent end
of the speed control rod faces rearward (Figure 5).
Figure 5
2. Secure the lower end of the speed control rod with the
washer and hairpin cotter that you previously removed.
3. Remove the hairpin cotter and the outer washer from
the trunnion on the upper end of the speed control
rod (Figure 6).
Figure 6
1. Speed selector lever
2. Wave washer
Note: To make installation easier, leave the wave
washer and the flat washer on the trunnion (Figure 6).
4. Shift the speed selector lever into Position R2.
5. Rotate the lower link arm fully upward
(counterclockwise) (Figure 7).
Figure 7
6. Lift up on the speed control rod and insert the trunnion
into the hole in the speed selector lever (Figure 6).
6
3. Trunnion
4. Flat washer