Cobra 29 LTD Classic User Manual page 7

Operation
Note
The reading will be slightly
higher on Channels 1 and 40
compared to Channel 20.
While still holding down the mic button, set
5
Note
the S/RF SWR CAL switch to the SWR position,
When switched to SWR position
to read the SWR reading.
the meter needle should ideally
be as far to the left as possible. Repeat the same steps two through five
6
Anything over 3 is not
on Channel 1 and 40. This will check SWR for
acceptable. The antenna all channels.
indicator will light. A slight
antenna height adjustment
(higher or lower) may be
required. Repeat recalibration
steps.
12
To Receive
Rotate the On/Off Volume knob clockwise
1
the green RX/TX LED will be illuminated.
13
Operation
To Receive