Cobra 29 LTD Classic User Manual page 3

Installation
Note
Connecting to an accessory fuse
prevents the unit from being left
on accidentally, and also
permits operating the unit
without running the engine.
Note
In positive ground vehicles the
red wire goes to the chassis and
the black wire is connected to
the ignition switch.
4 In a negative grounded vehicle, connect the
Note
red lead of the DC power cord to an accessory
Before installing the CB radio,
12 volt fuse.
visually check the vehicle's
battery connection to
Connect the black lead to the negative side of
5
determine which terminal,
the vehicle. This is usually the chassis. Any
positive or negative, is
convenient location with a good electrical
grounded (positive is the larger
contact (remove paint) may be used.
of the two) to the engine block
(or chassis). A negatively
grounded vehicle has its
negative lead grounded to the
chassis.
4
Plug power cable into back of unit marked
6
"Power". Be sure to observe polarity markings.
Mount the microphone
7
bracket on either side of
the unit (driver's left)
using two screws
supplied. Bracket should
be placed under the dash
so microphone is readily
accessible.
8 Attach the 4-pin microphone cable to
receptacle, on the front of unit and install unit
on bracket securely.
5
Installation