Toro 30686 Operator's Manual page 33

1. Control rod
2. Clevis pin
3. Operator Presence
Control lever (OPC)
4. Handle
2. Adjust the control rod length by threading the rod in
or out of the rod fitting until there is a 3/16 to 1/4
inches (5 to 6 mm) clearance between the control
rod and the bottom of the neutral/parking brake
lock (Figure 33).
1. Handle
2. Neutral/ parking brake lock 5. Forward speed
3. 3/16 to 1/4 inch (5 to 6
mm) clearance
3. Install the control rod to the drive lever and the
neutral/parking brake lock. Secure the control rod
with a clevis pin and a hairpin cotter (Figure 33).
Figure 32
5. Neutral lock
6. Hairpin cotter pin
7. Left handle shown
8. Drive lever
Figure 33
4. Drive lever
6. Control rod
4. Check the operation of the control rod. If you need
to adjust it, remove the hairpin cotter and the clevis
pin that secure the control rod to the drive levers.
5. Adjust the control rod length by repeating the
previous steps.
33