Table of Contents
Advertisement
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Clean the grease fittings with a rag. Make sure to
scrape any paint off the front of the fitting(s).
4. Connect a grease gun to the fitting. Pump grease
into the fittings until grease begins to ooze out of
the bearings.
5. Wipe up any excess grease.
Lubricating the Caster and
Wheel Bearings
Service Interval: Before each use or daily
Every 400 hours
Every 400 hours
1. Lubricate the front wheel bearings and front spindles
(Figure 19).
2. Lubricate the drive wheel bearings.
Figure 19
Greasing the Transmission
Couplers
Service Interval: Every 250 hours
Lubricate the transmission couplers located in the back
of the machine (Figure 20).
Greasing the Mower Belt Idler
Service Interval: Every 50 hours
Grease the fitting on the mower belt idler arm pivot
(Figure 21).
Note: Remove the mower deck cover to access the
grease fitting for the mower belt idler arm.
26
Figure 20
Figure 21
Advertisement
Table of Contents
