Audio & Video Setup - Samsung QND-6010R User Manual

auDio & viDeo Setup
video setup
1. From the Setup menu, select the <audio & video (
tab.
2. Click <video setup>.
3. Select a <video source> mode.
• Flip mode : Turn upside down the image that is captured
by the camera.
• Mirror mode : Flip horizontal the image that is captured by
the camera.
• Hallway view : Rotates the video captured by the camera
according to the set angle.
You can rotate the video 0, 90 or 270 degrees.
If you change settings, the browser window will be closed and the camera restarted. Please access again later.
`
4. Specify the privacy zone.
5. When done, click [apply ( )].
to set the privacy zone
You can specify a certain area of the camera video to be protected for your privacy.
1. Set it to <on>.
2. Click [apply ( )].
3. Drag the mouse over the video to select an area.
4. Enter the name and select the color, and then click [oK].
5. If you want to delete a name in the list, select it and click
[Delete ( )].
audio setup (QnD-6010r/6020r/6030r)
You can set the input value of the audio connected to the camera.
1. From the Setup menu, select the <audio & video (
tab.
2. Click <audio setup>.
3. Set the audio input value.
• Source : Sets the audio input.
- Internal microphone : Built-in microphone embedded in
the camera.
)>
)>
• Codec : Specify the audio codec.
- G.711 : A audio codec standard, it uses 64 Kbps PCM (Pulse Code Modulation) encoding.
ITU standard audio codec that is adequate for digital voice transfer in PSTN network or through a PBX.
- G.726 : ITU standard audio codec applying ADPCM (Adaptive Differential Pulse Code Modulation) for
variable bit rates of 40/32/24/16 Kbps to 64 Kbps PCM encoding.
• Bitrate : Set the bit rate to differentiate compression ratio if using G.726 codec.
• Gain : Specify the audio input amplification.
Sound quality deterioration or howling may occur if the loudness of the sound source or gain value were set excessively.
`
J
4. When done, click [apply ( )].
audio setup (Qno-6020r/6030r, Qnv-6010r/6020r/6030r)
You can set the input value of the audio connected to the camera.
1. From the Setup menu, select the <audio & video (
tab.
2. Click <audio setup>.
3. Set the audio input value.
• Source : Sets the audio input.
- Line : Connect the cable to the audio device.
- External microphone : Uses an external microphone.
• Apply power to Ext. Mic. : Select this check box when the external microphone is not powered, and the
power will be supplied from the camera to the microphone. You can configure settings when selecting
<external microphone>.
• Codec : Specify the audio codec.
- G.711 : A audio codec standard, it uses 64 Kbps PCM (Pulse Code Modulation) encoding.
ITU standard audio codec that is adequate for digital voice transfer in PSTN network or through a
PBX.
- G.726 : ITU standard audio codec applying ADPCM (Adaptive Differential Pulse Code Modulation) for
variable bit rates of 40/32/24/16 Kbps to 64 Kbps PCM encoding.
• Bitrate : Set the bit rate to differentiate compression ratio if using G.726 codec.
• Gain : Specify the audio input amplification.
Sound quality deterioration or howling may occur if the loudness of the sound source or gain value were set excessively.
J `
4. When done, click [apply ( )].
)>
English _43