Table of Contents
Advertisement
Installation
Preparation for installation
The cooker hood must be mounted so that the minimum
distance between the fi lters and the gas or electric hob is
45cm.
The ducting system for this cooker hood must not be
connected to an existing ventilation system which is being used
for any other purpose.
We recommend an air exhaust tube which is the same
diameter as the air exhaust outlet hole. If a two-part air
exhaust tube is used, the upper part must be placed outside
the lower part.
If installing this cooker hood between adjoining wall cabinets,
the wall cabinets must not overhang the hob.
Before beginning installation, remove the fi lters (see page 8).
This will make the unit easier to handle during installation.
Installing the Cooker Hood
1 Mark the lower position of the cooker hood on the wall,
making sure it is not below the minimum distance from the
hob.
10
min 45 cm
2 Place the fi xing template against the wall, lining the bottom
holes up with the line drawn in step 1.
3 Drill four holes and place rawlplugs in each.
4 Insert the top two screws and and tighten, leaving at least
3mm protruding from the wall.
5 Lift the cooker hood up to the wall, hooking it on to the
two screws.
6 Tighten the screws to hold the cooker hood fi rmly against
the wall.
Cooker hood user guide
Advertisement
Table of Contents
