Contents Contents Introduction Safety is important In the box Safety information Important safety information Warnings Cautions Electrical information Mains supply Operation Controls Indicators Care, Cleaning and Servicing Care and Cleaning Cleaning and Replacing Filters Aluminium Filters Charcoal Filters (Not Supplied) Replacing Lights Servicing Installation...
Introduction Thank you for purchasing this JLBIHD622 cooker hood. Please take time to read these instructions and retain for future reference. Safety is important To ensure your safety and the safety of others, please read the Safety information before you operate this product.
To avoid accidents to property or people it is important to carefully before use follow the instructions given. Failure to do so removes any liability from John Lewis. Take note of the following safety information: Warnings Warning! To prevent fi re or shock hazard, do not expose this cooker hood to rain or •...
Electrical information Cautions • This cooker hood is designed for domestic use only. Mains supply • This cooker hood is designed to be operated by adults. Children should not be allowed to tamper with the controls Should the power supply cable need to be replaced, this or play with the cooker hood.
Operation Controls Indicators The indicators are lit when the associated button in pressed. In addition, they can indicate the following: Filters. If this indicator is: Flashing once every two seconds. The anti-grease The controls are (left to right): fi lters must be washed. Light.
Care, Cleaning and Servicing Charcoal Filters (Not Supplied) Note: Switch off and unplug the cooker hood before carrying out any cleaning or maintenance work. Charcoal fi lters are designed to absorb grease, dust and unwanted odours during cooking. They cannot be washed or Care and Cleaning re-used and they must be replaced at least every four months.
Replacing Lights Your cooker hood is fi tted with LEDs. They should only be replaced by an authorised service engineer. Servicing This cooker hood should only be serviced by an authorised service engineer, and only genuine spare parts should be used. Under no circumstances should you attempt to repair the cooker hood yourself.
Installation Preparation for installation 2 Place the fi xing template against the wall, lining the bottom holes up with the line drawn in step 1. The cooker hood must be mounted so that the minimum distance between the fi lters and the gas or electric hob is 45cm.
If Your Extractor Hood Does Not Have 7 Insert the bottom two screws (A) and and tighten. Decorative Ducts 8 Remove the four screws holding the lid of the cooker hood. 9 Remove the lid and detach the grid from the air outlet hole.
Page 12
Installation 10 Pass a fl exible air exhaust tube (not supplied) through the 13 Insert the fi lters, as described on page 8. cooker hood lid and connect it to the cooker hood. 14 Connect your cooker hood to the electrical supply. max 90 cm Your cooker hood is now ready for use.
If Your Extractor Hood Has Decorative 12 Adjust the width of the support bracket, then screw it to the wall. Ducts 13 Connect the air exhaust tube to the cooker hood. 8 Make sure that the electrical power supply is within the measurements for the decorative connector.
Installation If You Have Circular Active Carbon 16 Pull the top duct up to the support bracket. Filters 17 Insert screws and tighten to fasten the top duct to the support bracket. If you have circular active carbon fi lters, they are fi tted in the extraction assembly inside the cooker hood.
If You Have a Bracket to Hold Active Carbon Filters If you have active carbon fi lters to be fi tted in the front of the cooker hood, you will also have a bracket and screws to hold the fi lters in position. If so, screw the bracket into position before inserting your active carbon fi...
John Lewis branch where you purchased the product. Guarantee Your John Lewis JLBIHD622 cooker hood is covered by a three year parts and labour guarantee. This means that if the cooker hood develops a fault during the guarantee period we arrange a repair free of charge.
Replace the fuse. If you are unsure how to replace a fuse consult a qualifi ed electrician. If none of the above suggestions resolve the problem please contact your local John Lewis branch. Never attempt to repair the cooker hood yourself.
When you contact your local service engineer you will need to persons may cause injury or serious malfunctioning. give the following details: Contact your local John Lewis branch. • Your name, address and post code • Your telephone number • Clear and concise details of fault •...
Specifi cations Specifi cations of the cooker hood that you have just purchased may vary from the information in this table due to technical innovations. Type Cooker Hood Dimensions 600 mm wide x 345 mm high Drive Mode Extraction Rate (per hour) 750 m3 Number of Speeds 3 + intensive...