Dos And Don'ts - Cuisinart Smooth Operator SMO-56 Instruction And Recipe Booklet

DOS AND DON'TS WHEN USING
YOUR BLENDER
DO:
• Make sure the electrical outlet is rated at the same voltage as that stated
on the bottom of the blender motor base.
• Always use the blender on a clean, sturdy and dry surface.
• Always add liquid ingredients to the blender jar first, then add
remaining ingredients. This will ensure that ingredients are
uniformly mixed.
• Cut most foods into cubes approximately
cm) to achieve a more uniform result. Cut all cheeses into pieces no
larger than 1 ⁄ inch (1.3 cm).
2
• Use the measured pour lid to measure liquid ingredients such as alcohol.
Replace measured pour lid or blending stick after ingredients have
been added.
• Use a rubber or plastic spatula as needed, only when the blender is
turned off. Never use metal utensils, as damage may occur to the blender
jar or cutting assembly.
• Place cover on firmly. Always operate the blender with the cover on.
• Make sure locking ring with cutting assembly is tightly attached to
blender jar.
• Always remove locking ring with cutting assembly, rubber gasket,
dispenser tap and dispenser plug before cleaning.
• When scraping the blender jar with a spatula, remove the food from the
sides of the blender jar and place food in the center of the blender jar,
over the cutting assembly.
• When chopping fresh herbs, garlic, onion, zest, bread crumbs, nuts,
spices, etc, make sure the blender jar and cutting assembly are com-
pletely dry.
• If food tends to stick to the sides of the blender jar when blending, use
blending stick and pulse in short bursts.
• Pulses should be short bursts. Space the pulses so the blades stop rotat-
ing between pulses.
• Always use blending stick with cover in place.
1 ⁄ inch (1.3 cm) to 1 inch (2.5
2
DON'T:
• Don't store food or liquids in your blender jar.
• Don't place locking ring with cutting assembly onto motor base without
the blender jar attached.
• Do not attempt to mash potatoes, knead heavy dough, or beat egg whites.
• Don't remove blender jar while unit is on. Keep the blender jar cover on
the blender jar while blending.
• Don't twist locking ring from blender jar when removing blender jar from
motor base. Simply lift blender jar from motor base.
• Don't overblend foods. Blender will achieve most desired results in
seconds, not minutes.
• Don't overload blender. If the motor stalls, turn the blender off immediately,
unplug the unit, and remove a portion of the food, then continue.
• Don't use any utensil, other than the blending stick provided, inside the
blender jar while the motor is on. Note: Blending stick is to be used only
with cover in place.
• Don't use any container or accessories not recommended by Cuisinart.
Doing so may result in injury.
• Don't place hands inside the blender jar or insert fingers into the
dispenser hole when blender is plugged in.
• Don't add boiling liquids or frozen foods (except ice cubes or
pieces of frozen fruit) to glass blender jar. Boiling liquids should cool for
5 minutes before being placed in blender jar.
⁄ -inch
1
2
7