Warning Indicators; Childproof Lock - Beko DV 7120 User Manual

Auxiliary function
Cancel audio warning
Your dryer will give an audio warning when the programme
comes to an end. If you do not want to hear the audio
warning, press "Cancel Audio Warning" button. The
relevant light will turn on when this button is pressed and
an audio warning will not be given when the programme
comes to an end.
C
You can select this function either before or after the
programme starts.

Warning indicators

C
Warning indicators may differ according to the model
of your dryer.
Filter cleaning
A warning light will turn on to remind filter cleaning after
the programme finishes.
C
If the filter cleaning warning light lights up
continuously, please refer to, "Suggested solutions
for problems".
Starting the programme
1. Press "Start/Pause/Cancel" button to start the
programme.
2. Light of the "Start/Pause/Cancel" button will turn on
to indicate that the programme has started.
Progress of program
Progress of a running program is shown through the
program follow-up indicator.
At the beginning of every program step, the relevant
indicator LED will light up and light of the completed step
will turn off.
"Drying":
Drying level will be illuminated during the whole drying
process until the drying degree reaches "iron dry".
"Iron Dry":
Starts to illuminate when the drying degree reaches "iron
dry" step and remains illuminated until the next step.
"Ready to wear":
Starts to illuminate when the drying degree reaches
"Ready to wear" step and remains illuminated until the
next step.
"Final / Anti-creasing":
Illuminates when the program comes to an end and anti-
creasing function is activated.
C
If more than one LED light up or flash concurrently,
it means there is malfunctioning or a failure (please
see, Solution suggestions for problems).
Changing the programme after it has started
You can use this feature to dry your clothes under higher
or lower temperatures after your dryer has started.
For example;
1. Press and hold the "Start/Pause/Cancel" button for
about 3 seconds to "Cancel" the programme in
order to select "Extra Dry" programme instead of
"Iron Dry" programme.
2. Select the "Extra Dry" programme by rotating the
programme selection button.
3. Press "Start/Pause/Cancel" button to start the
programme.
C
Press "Start/Pause/Cancel" button for 3 seconds
to cancel the programme or turn the programme
selection knob in any direction to end the
programme while the machine is running. Water
tank and filter cleaning warning lights turn on to
warn the user when the programme is cancelled
by pressing the "Start/Pause/Cancel" button for 3
seconds. However, the warning lights do not turn
on when the programme is cancelled by turning the
programme selection knob. Only the drying light
turns on and the machine remains in hold until a
new programme is selected and the "Start/Pause/
Cancel" button is pressed. Child-proof lock of the
machine should not be active in order to perform
these two operations. If the child-proof lock is active,
deactivate it before performing these operations.
Adding/removing laundry in standby mode
In order to add or remove laundry after the programme
starts:
1. Press the "Start/Pause/Cancel" button to switch the
dryer to "Pause" mode. Drying process will stop.
2. Open the door at "Pause" position and close it again
after adding or taking out laundry.
3. Press "Start/Pause/Cancel" button to start the
programme.
C
Any laundry added after the drying process has
started may cause the dried clothes in the machine
intermingle with wet clothes and the result will be
wet laundry after the drying process is over.
C
Laundry may be added or taken out as much as
desired during a drying process, but this process will
extend the programme duration and increase energy
consumption since the drying will be interrupted
continuously. Therefore, it is recommended to add
laundry before the drying programme has started.
Child-proof lock
There is a child-proof lock to prevent any programme
interruption due to the pressing of button while the
programme is running. The loading door and all buttons
except the "On/Off" button on the control panel are
deactivated when the child-proof lock is active.
Press the "Start/Pause/Cancel" and "Cancel audio
warning" buttons simultaneously for 3 seconds to activate
the child-press lock.
To start a new programme after the programme is over or
to interrupt the programme, the child-proof lock should be
deactivated. Press the same buttons for 3 sec. again to
deactivate the child-proof lock.
C
Child-proof lock is deactivated when the machine is
restarted by pressing the On/Off button.
13 EN