Table of Contents
Advertisement
Available languages
Available languages
Adjusting feet
In order to ensure that your product operates more silently
and vibration-free, it must stand level and balanced on its
feet. Front feet of your product can be adjusted. Balance
the machine by adjusting the feet.
1. Loosen the feet by hand.
2. Adjust the feet until the product stands level and firmly
on the floor.
C
Do not use any tools to loosen the adjustable feet,
otherwise, they can be damaged.
C
Never remove the adjustable feet from their
housings.
C
You may supply 2 plastic pieces from an Authorized
Service with 2951620100 part number. These
parts prevent your machine from slipping when
the machine locates on wet and slippery surfaces.
You may assemble mentioned parts to the front
adjustable feet by fitting and pressing them to snap
into ground of feet.
Electrical connection
Connect the machine to a grounded outlet protected
by a fuse of suitable capacity as stated in the technical
specifications table. Our company shall not be liable for
any damages that will arise when the machine is used on
a circuit without grounding.
•
Connection must comply with national regulations.
•
If the current value of the fuse or breaker in the
house is less than 16 Amps, have a qualified
electrician install a 16 Amp fuse.
•
Power cable plug must be within easy reach after
installation.
•
The voltage and allowed fuse or breaker protection
are specified in the "Technical Specifications"
section.
•
The specified voltage must be equal to your mains
voltage.
•
Do not make connections via extension cables or
multi-plugs.
•
The main fuse and switches must have a contact
distance of minimum 3 mm.
B
Damaged power cable must only be replaced by a
qualified electrician.
B
If the product is faulty, it must not be operated unless
it is repaired! There is the risk of electric shock!
First use
•
To have the product ready for operation before
calling the authorised service agent, make sure
that its location and power supply installations
are appropriate. If they are not, call a qualified
electrician to have any necessary arrangements
carried out.
•
Make sure that the power connections of the
product are in accordance with the instructions
given in relevant chapters of this manual.
Transportation of the machine
1. Unplug the machine from the mains.
2. Remove the water drain (if any) and chimney
connections.
3. Drain water remained in the machine completely
before transportation.
6 EN
Advertisement
Table of Contents
