Dispenser Trim - Monogram ZISB360DH Manual

Monogram 36" Built-In Side-by-Side Refrigerator
®

DISPENSER TRIM

A
Freezer Door
Ice/Water Dispenser
3/4" Flush Panel
3/4" OVERLAY PANEL
DISPENSER TRIM
RAISED PANEL DESIGN ON DISPENSER MODELS
16 3/4"
10 5/8"
DISPENSER TRIM
Freezer Door
1/4" Backer Panel
.10" Spacer Panel
Ice/Water Dispenser
1/2" Overlay Panel
1/2" OVERLAY PANEL
DISPENSER TRIM
3/4" or 1/2" Flush Panel
B
SIDE VIEW CROSS SECTION
(Showing Raised Panel with
Middle Rail)
FLUSH INSET INSTALLATION
NOTES
.85"
Total
Thickness
These refrigerators are supplied with
a dispenser trim for flush inset panels.
A Panel Dispenser Trim:
The provided dispenser trim is designed
to fit a total panel thickness of 3/4"
or 0.85".
• If the panel is less than 3/4" thick, a
noticeable gap may be created around
the dispenser trim.
• If the panel is more than 0.85" thick,
the dispenser trim cannot be secured
to the door.
• The overlay panel must be constructed
according to the specifications shown
to achieve the correct total thickness.
• When a raised panel design is to be used,
a custom middle rail is required.
Raised Panel Design on Dispenser Models:
When a raised panel design is to be used, a
custom wide middle rail is required to accept
the dispenser trim.
3/4" or .85"
Total
Thickness
B • The middle rail must be wide enough to
C
allow for the dispenser trim to overlap
the opening.
C • The middle rail must be 3/4" total
thickness for 3/4" panels or 0.85" total
thickness for 1/2" panels to accept the
dispenser trim.
ZISB360DH
Product Specification Revised 2/15