Dispenser Trim - Monogram ZISB480DH Dimension Manual

Monogram 48" Built-In Side-by-Side Refrigerator
®

DISPENSER TRIM

A
Freezer Door
Ice/Water Dispenser
3/4" Flush Panel
3/4" OVERLAY PANEL
DISPENSER TRIM
RAISED PANEL DESIGN ON DISPENSER MODELS
16 3/4"
10 5/8"
DISPENSER TRIM
Freezer Door
1/4" Backer Panel
.10" Spacer Panel
Ice/Water Dispenser
1/2" Overlay Panel
1/2" OVERLAY PANEL
DISPENSER TRIM
3/4" or 1/2" Flush Panel
B
SIDE VIEW CROSS SECTION
(Showing Raised Panel with
Middle Rail)
FLUSH INSET INSTALLATION
NOTES
.85"
Total
Thickness
These refrigerators are supplied with a
dispenser trim for flush inset panels.
A Panel Dispenser Trim:
The provided dispenser trim is designed
to fit a total panel thickness of 3/4"
or 0.85".
• If the panel is less than 3/4" thick, a
noticeable gap may be created around the
dispenser trim.
• If the panel is more than 0.85" thick, the
dispenser trim cannot be secured to
the door.
• The overlay panel must be constructed
according to the specifications shown to
achieve the correct total thickness.
• When a raised panel design is to be used,
a custom middle rail is required.
Raised Panel Design on Dispenser Models:
When a raised panel design is to be used,
a custom wide middle rail is required to
accept the dispenser trim.
3/4" or .85"
Total
Thickness
B • The middle rail must be wide enough
C
to allow for the dispenser trim to
overlap the opening.
C • The middle rail must be 3/4" total
thickness for 3/4" panels or 0.85" total
thickness for 1/2" panels to accept the
dispenser trim.
ZISB480DH
Product Specification Revised 2/15