Kenwood KMM-203 Instruction Manual page 16

INSTALLATION/CONNECTION
Installing the unit (in-dash mounting)
Hook on the top side
Orientate the trim plate as
illustrated before fitting.
How to remove the unit
1 Detach the faceplate.
2 Remove the trim plate.
3 Insert the extraction keys deeply into
the slots on each side, then follow the
arrows as shown on the illustration.
16
ENGLISH
Do the required wiring.
( 17)
Dashboard of
your car
Bend the appropriate tabs to hold the
mounting sleeve firmly in place.
When installing without the mounting sleeve
1 Remove the mounting sleeve and trim plate from the unit.
2 Align the holes in the unit (on both sides) with the vehicle mounting bracket
and secure the unit with screws (supplied).
The following screws are supplied:
Round head screws (M5 × 8 mm)
Flat head screws (M5 × 8 mm)
Sems screws (M4 × 8 mm)
Use only the specified screws. Using wrong screws might damage the unit.
Part list for installation
(A) Faceplate (B) Trim plate
(D) Extraction key
× 4
To secure the mounting
bracket
× 4
To secure the ground
× 1
wire (black)
(C) Mounting sleeve
(E) Wiring harness