Table of Contents
Advertisement
"Hi" the line-level input is enabled.
When it is "Lo" the mic input is
enabled.
Figure 3.5 shows how to connect
a remote switch (or logic line) to
each channel using the remote
connector.
Fig. 3.5 Remote Switch Wiring
Page 10
Ground Isolation
If present, ground loop problems
can be reduced by unsoldering or
cutting and removing the ground
jumper shown in Figure 2.1.
When removed, the signal ground
is isolated from the chassis ground
by a 2.7 ohm resistor as shown
below:
Fig. 3.6 Ground Isolation
P .I.P .–PA
Advertisement
Table of Contents
