Technical Specifications - Axis P3707-PE User Manual

AXIS P3707-PE Network Camera

Technical specifications

Technical specifications
You can find the latest version of the datasheet at www.axis.com
LED Indicators
Status LED
Unlit
Green
Amber
Amber/Red
SD card slot
NOTICE TICE
NO NO TICE
• Risk of damage to SD card. Do not use sharp tools, metal objects or excessive force when inserting or removing the
SD card. Use your fingers to insert and remove the card.
• Risk of data loss and corrupted recordings. Do not remove the SD card while the product is running. Disconnect power or
unmount the SD card from the Axis product's webpages before removal.
This product supports SD/SDHC/SDXC cards (not included).
For SD card recommendations, see www.axis.com
Control Button
For location of the control button, see Hardware overview on page 7 .
The control button is used for:
• Resetting the product to factory default settings. See page 48.
• Connecting to an AXIS Video Hosting System service. See page 40. To connect, press and hold the button for about 3
seconds until the Status LED flashes green.
• Connecting to AXIS Internet Dynamic DNS Service. See page 40. To connect, press and hold the button for about 3 seconds.
Restart button
Press the restart button to restart the product.
Connectors
Network connector
RJ45 with High Power over Ethernet (High PoE).
NO NOTICE NO TICE TICE
Due to local regulations or the environmental and electrical conditions in which the product is to be used, a shielded network
cable (STP) may be appropriate or required. All cables connecting the product to the network and that are routed outdoors
or in demanding electrical environments shall be intended for their specific use. Make sure that the network devices are
installed in accordance with the manufacturer's instructions. For information about regulatory requirements, see the
Installation Guide available at www.axis.com
Indication
Connection and normal operation.
Shows steady green for 10 seconds for normal operation after startup completed.
Steady during startup. Flashes during firmware upgrade or reset to factory default.
Flashes amber/red if network connection is unavailable or lost.
52