H3C S3100-52P Installation Manual page 42

Installation Manual
H3C S3100-52P Ethernet Switch
Figure 5-5 Sending File interface
Step 9: After completing loading, the system displays the following information:
Loading ...CCCCCCCCCC done!
Note:
You do not need to reset the HyperTerminal's baud rate and can skip the last step if you
have chosen 9600 bps. In this case, the system does not display the above prompt
message but "BootROM is updating now.....................................done!" instead.
Step 10: Reset HyperTerminal's baud rate to 9600 bps with reference to Steps 5 and 6
described above. Then, press any key as prompted. The system will display the
following information when it completes the loading.
Bootrom updating.....................................done!
III. Loading host software
Follow these steps to download host software of the switch:
Step 1: Select <1> in the Boot Menu. The system displays the following information:
1. Set TFTP protocol parameter
2. Set FTP protocol parameter
3. Set XMODEM protocol parameter
0. Return to boot menu
Enter your choice(0-3):3
Select <3>. The subsequent steps are the same as those for loading Boot ROM, except
for the program to be downloaded in prompt messages.
Chapter 5 Loading Boot ROM and Host Software
5-10