Chapter 3 Installing The Switch; Installing A Switch; Cabinet Mounting - H3C S3100-52P Installation Manual

Hide thumbs Also See for S3100-52P:

Table of Contents

Installation Manual

H3C S3100-52P Ethernet Switch

Chapter 3 Installing the Switch

Caution:

When you ask your sales agent to maintain the switch, you must ensure that the

dismantlement-preventive seal on a mounting screw of the switch chassis is intact. If

you want to open the chassis, you should contact the agent for permission. Otherwise,

you will bear any consequence resulted from your actions without permission.

You can install a switch into a 19-inch standard cabinet in one of the following four

ways:

Use front mounting ears

Use front mounting ears and a tray

Use front mounting ears and guide rails

Note:

Guide rails purchased from H3C apply only to standard cabinets 1,000 mm (39.4 in)

deep. Use other supports to substitute for guide rails in the case of other cabinet

depths.

I. Introduction to mounting ear

Figure 3-1 shows the appearance of a front mounting ear.

3-1

Chapter 3 Installing the Switch

Table of Contents