H3C S3100-52P Installation Manual page 32

Installation Manual
H3C S3100-52P Ethernet Switch
Press Ctrl-B to enter Boot Menu... 5
To enter the Boot Menu, press <Ctrl+B> within five seconds after the message "Press
Ctrl-B to enter Boot Menu... 5" appears. If not, the system automatically boots and
displays:
Auto-booting...
Decompress Image............................................
............................................................
............................................................
............................................................
.................OK!
Starting at 0x80100000...
User interface aux0 is available.
Press ENTER to get started.
The appearance of "Press ENTER to get started" indicates that the switch has
completed its automatic boot.
Press <Enter>; the system displays:
<H3C>
You can configure the switch now.
Note:
If the specified host software does not exist, the switch will automatically choose an
existing valid host software to boot.
A wide range of command views are available for H3C Series Switches. For more
information on configuration commands and command line interfaces, refer to H3C
S3100-52P Ethernet Switch Operation Manual and H3C S3100-52P Ethernet
Switch Command Manual.
Initialize LSJ1LTSE........................OK!
SDRAM fast selftest........................OK!
Flash fast selftest........................OK!
CPLD selftest..............................OK!
Switch chip selftest.......................OK!
PHY selftest...............................OK!
Please check port leds...............FINISHED!
4-7
Chapter 4 Starting up the Switch at the Initial Boot