H3C S3100-52P Installation Manual page 18

Hide thumbs Also See for S3100-52P:

Table of Contents

Installation Manual

H3C S3100-52P Ethernet Switch

Place the switch horizontally in a proper position, and fix the other end of mounting

ears to the front brackets with screws and captive nuts, as shown in Figure 3-3.

Figure 3-3 Fix front mounting ears (2)

III. Use front mounting ears and a tray

Follow these steps to install a switch into a 19-inch standard cabinet:

Wear an ESD-preventive wrist strap to check the grounding and stability of the

cabinet.

Fix the delivered tray horizontally in a proper position.

Take out the screws which are packed together with the front mounting ears, and

fix one end of mounting ears to the switch, as shown in Figure 3-2.

Place the switch on the tray horizontally, slide the tray into the cabinet, and fix the

other end of mounting ears to the front brackets with crews and captive nuts, as

shown in Figure 3-3.

IV. Use front mounting ears and guide rails

Introduction to guide rail

Figure 3-4 shows the appearance of a guide rail.

Front square-holed

Front

mounting ear

3-3

Chapter 3 Installing the Switch

bracket

ont mounting ear

Front panel

Table of Contents