Installation; Prepare The Iq-P.i.p.-Smt; Iq Address Switch (Sw1) Location - Crown IQ-P.I.P-SMT Reference Manual

Fig. 4.1 IQ Address Switch (SW1) Location

4 Installation

Before beginning, please carefully
note:
CAUTION: STA A A A A TIC ELECTRICITY CAUTION: ST CAUTION: ST TIC ELECTRICITY TIC ELECTRICITY
CAUTION: ST CAUTION: ST TIC ELECTRICITY TIC ELECTRICITY
MAY DAMAGE THE MA MA MA MA Y DAMAGE THE Y DAMAGE THE IQ–P Y DAMAGE THE Y DAMAGE THE IQ–P.I.P IQ–P IQ–P IQ–P
MODULE. MODULE.
MODULE. MODULE. MODULE. Use caution when han-
dling the unit. Carefully ground your-
self BEFORE touching
IQ–P.I.P.–SMT module. For added
safety, touch the outer metal collar of
either Crown Bus connector (see Fig-
ure 2.1). This should safely discharge
any static electricity through the
ground plane of the module. Avoid
unnecessarily touching the compo-
nents, edge connector or solder
pads on the circuit boards.
NOTE — Amplifier Compatibility
The version of the IQ-P.I.P.-SMT card
you received will vary depending on
whether you indicated the card will
be installed on a PIP2-compatible
amplifier (such as the Crown MA-
5000VZ or CT-10 Series amplifiers).
The correct card to install in a PIP2-
compatible amplifier is the IQ-P.I.P.-
1 IQ-P.I.P.-SMT-PIP2 has SIPS installed; IQ-P.I.P.-SMT has SIPS removed.
Page 18
SMT-PIP2 . The standard IQ-P.I.P.-
SMT should be ordered for non-PIP2-
compatible amplifiers.
Should you later wish to change the
amplifier you are using for your IQ-
.I.P. . . . . –SMT .I.P .I.P .I.P –SMT –SMT –SMT –SMT
P.I.P.-SMT installation, it is possible to
alter the card's configuration by sim-
ply removing or installing two SIPS
the
from the card's circuit boards
structions on installing or removing
these SIPS, contact Crown Technical
Support.
4.1 Prepare the IQ–P.I.P.–SMT
1. Set the IQ address switch
SW1. By giving each IQ com-
ponent a unique address, it
can be individually controlled
and monitored. Whenever the
IQ System wants to send a
command to just one IQ com-
ponent, it first sends its ad-
dress and then the command
down the Crown Bus.
The 8-segment DIP switch
(SW1) shown above is used
IQ P.I.P.–SMT
1 . For in-