Installing The Display Assembly - Dell Precision 17 7710 Owner's Manual

5. Perform the following as shown in the illustration:
a. Remove the screws that secure the eDP cable bracket [1].
b. Remove the eDP cable bracket [2].
c. Peel off the tape on the heat pipe and disconnect the eDP cable from the system board [3].
d. Remove the screws that secure the display assembly to the computer and remove it from the
computer [4] .

Installing the display assembly

1. Tighten the screws to secure the display assembly in place.
2. Affix the tape on the heat pipe.
3. Connect the eDP cable to the correct connectors on the system board.
4. Insert the wireless antenna cables through the routing hole on the chassis.
5. Tighten the screws at the bottom and back of the computer.
6. Align the display hinge cap and tighten the screws to secure it to the computer.
7. Route and connect the antenna cables to their connectors.
8. Install the:
a. palmrest
30