Problems With Your Wine Dispenser; Troubleshooting - Vinotemp VT-WINEDISP2 Owner's Manual

PROBLEMS WITH YOUR WINE DISPENSER

Most common problems can be solved easily, saving you the cost of a possible service call. Try
the suggestions below to solve the problem before contacting Vinotemp at info@vinotemp.com.
Dispensing System
Complaint
One canister only
dispensing 1 or 2
bottles, gas
leaking/escaping
Unit not dispensing
Dispensing
interrupted or slow
Wine spurting or
spitting
12

TROUBLESHOOTING

Possible Causes
a. Canister gasket unaligned, bad or
missing
b. Canister not tightened
c. Gas tube broken
d. Gas tube not tightened at the
regulator or valve
e. Regulator leak
f. Gas valve stuck open
g. Bottle not tightened
a. Argon/Nitrogen leak
b. Defective pressure regulator
c. Bottle neck not tightened or
defective plug
d. Defective gas solenoid valve or
incorrect wiring
e. Defective wine solenoid valve or
incorrect wiring
f. Incorrect or loose wirings,
defective power board or control
board
a. Argon/Nitrogen low
b. Gas tubes kinked or twisted
c. Bottle neck not tightened
d. Gas solenoid valve restricted
e. Wine solenoid valve restricted
a. Wine tube is restricted
b. Bottle is near empty and there is
too much gas in the bottle
c. Gas pressure is too high
d. Wine solenoid valve is dirty
W W W . V I N O T E M P . C O M
Response
a. Align, change or install the gasket
b. Turn the canister clockwise all the way
c. Change the gas tube
d. Check for these connections
e. Check for gas escaping at the regulator
f. If gas continues to escape from the gas tube,
check for gas valve and wirings
g. Check the plug/fixer
a. If none of the spouts dispense wine, check for
canister pressure gauge or turn the canister
slightly counter clockwise to see if any gas
escapes (turn clockwise to re-tighten), then
check for gas leaking as instructed above
b. If none of the spouts dispense wine and the
canister has pressurized gas, check the
regulator
c. Press dispense button to check if gas is
escaping from the plug or fixer
d. Press the dispense button to see of gas is
escaping out of the gas tube
e. Switch the questionable valve to a working
spout and check to see if problem still exists
f. Check all wirings and connections
a. If all spouts are dispensing wine slowly, check
the gas pressure and install a new canister if
necessary
b. Press dispensing button to see if gas is
escaping out of the gas tube slowly
c. Check the bottle plug and fixer for escaping
gas
d. Remove bottle, press dispensing button to
see if gas is escaping out of the gas tube
e. Switch the to a working spout to check
a. Check for any restrictions
b. Change the empty wine bottle out for a full
one
c. Replace the pressure regulator
d. Clean solenoid valves
12