Vinotemp VT-WINEDISP2 Owner's Manual page 9

Attaching and Removing Wine Bottles
1. Unscrew lower part of bottle fix nut and place it on the neck of desired wine bottle.
2. Slide bottle upward, with gas and wine tube inside the bottle.
3. Fit bottle mouth into silicon plug. If bottle mouth is larger, lift upper part of bottle fix
nut to free silicon plug completely and ease bottle mouth into the silicon plug first.
4. Tighten lower part of bottle fix nut to the upper part.
5. Press the dispensing button to allow wine out and check to see if gas leakage will
occur. (Reconnect tighter if needed so gas does not escape.)
6. Place wine fully in refrigerated cabinet and close door.
Once the wine dispenser is positioned and plugged in, turn the power on.
Dispensing Wine
The wine dispenser features two sets of two dispensing buttons, each positioned directly above
its corresponding wine bottle spout. The two dispensing button options are:
•
Press and hold the
into your glass. Wine will continue to be dispensed until the button is released.
•
Press the
dispense 1oz, twice to dispense 2oz, and so forth.
Resetting the 1 oz. portion control setting: The 1 oz. preset portion control setting can be
•
reset by the user. To set the portion control, press and hold the
shows "H2" and the previously set portion amount begins to flash. Using the
buttons, you can increase or decrease the portion control settings in 1 oz. increments
until you reach your desired setting.
Calibrating the portion: If the amount of wine dispensed varies, additional calibration may
•
be used to correct the dispensed portion of wine. To calibrate the portion control setting,
press and hold the
control amount begins to flash. Using the
the portion control settings if necessary. Once you have checked the portion control
setting, press the
may need to repeat this procedure several times until the correct portion is dispensed.
7 3 2 S o u t h R a c e t r a c k R o a d , H e n d e r s o n , N e v a d a 8 9 0 1 5
button over the desired spout to begin dispensing wine
button to dispense wine in 1oz increments. Press it once to
button until the display shows "H3" and the previously set portion
button to dispense wine and verify the amount poured. Note: You
i n f o @ v i n o t e m p . c o m
PRESSURE
GAUGE
button until the display
or buttons, you can increase or decrease
or
9